4mm nylon wheel nuts (4)
Screws, 3x10mm roundhead machine (6)
Screws, 4x12mm countersunk machine (100-degree) (6)
Antenna boot (rubber) (1)/ on-off switch cover (rubber) (1)
Screws, 3x8mm roundhead machine (6)
Screws, 3x6mm roundhead machine (6)
Servo horn, throttle-brake (Traxxas/Futaba compatible)
Rods, throttle-brake
Fuel line (1 foot)
Dust boot, throttle
Exhaust header gasket (1)/ gaskets, pressure fitting (2) (for side exhaust engines only)
Shoulder nut, 5mm
Set (grub) screws, 5x6mm (6)
Pipe coupler, molded (for use with pipes 5152 (T-Maxx) & 4452R) (TRX 2.5, 2.5R, 3.3)
Flathead engine mount screws 3x10, hex head, machine
Coupler, exhaust (silicone)
Lead wire, glow plug (blue) (EZ-Start and EZ-Start 2)
Lead wire, glow plug (blue) (EZ-Start and EZ-Start 2)/ molex pin extractor (use where glow plug wire does not have bullet connector)
Stub axle pins (4)
Exhaust pipe hanger, metal (N. Rustler/4-Tec) (side exhaust engines only)
Brake brackets (inner & outer)
Springs (front/ rear) (2)
Exhaust hanger, metal
Mounting plate, receiver
Mounting plate, receiver (grey)
Springs, rear (black) (2)
Glow plug wrench (universal wrench)
SPRINGS(2)(F/R)SLEDGEHAMMER
Exhaust pipe hanger, metal (N. Sport) (side exhaust engines only)
Springs, front (black) (2)
Pull ring, starter
Bearing spacers, clutch bell 5x8.5x1.75mm (1)/ 5x11x1.1mm (1)
Nuts, 5mm nylon locking (8)
Washer, 7x10x1.0 (2), 7x10x0.5 (1) black steel (shims for flywheel spacing), Washer, 5x8.2.8 brass (1) (shim for clutch bell spacing) for Revo Big Block Kit
Rod ends (GTR shocks) (6)
O-ring, fuel tank cap (Revo) (2)
Hanger, metal (for tuned pipe)/ 4x8 BCS (1)/ 3x10 BCS (1)
Clutch guard
E-clip set for Monster Buggy
Seal, stuffing tube (1)/ push rod (1)
Hanger, metal wire (for tuned pipe)/ 4mm GS (1)/ 4x10 BCS (1)
Pull handle, recoil starter/ shock absorber (TRX 2.5, 2.5R)
Rings, retainer (snap rings) (22mm) (2)
Exhaust pipe hanger, metal (T-Maxx) (side exhaust engines only)
Rings, retainer (snap rings) (14mm) (2)
Hanger, metal wire (for Resonator pipe in T-Maxx with long wheelbase)
Hanger, metal (T-Maxx/S-Maxx) (TRX 2.5, 2.5R)
Screws, 2.6x8mm countersunk machine (6)
1/8" DIFF BALLS (10)